PowerTector Automatic Referencing Solid State Battery Guards

Product Code: BAT-250-20

£31.18 (Ex. VAT) £37.42 (Inc. VAT)

The PowerTector Automatic Referencing Solid State Battery Guard is a solid state automatic referencing battery device that will monitor the source voltage and disconnect the equipment from the vehicle battery if the voltage falls below a pre-determined level. This can work to ensure that there is always sufficient voltage remaining in the battery to start a vehicle engine or ensure power is available for other critical applications. The total discharge of a lead acid battery can also cause damage to the cells significantly shortening the life of the battery. The PowerTector unit can also be set to disconnect equipment at a lower voltage that will still protect the battery from total discharge, while allowing for maximum battery usage. A timed version is also available which automatically disconnects a set period after the ignition has been switched off.

A Wide Range of Features
There are six units in the range from 20A to 200A. The 20A unit offers a simple in-line system, usually wired to a specific piece of equipment. These units do not require chassis mounting and simply connect and tie wrap neatly within the wiring system. The 40A and 60A units are connected by M6 brass bolts, the 100A and 200A by M10 brass bolts and use a three point mounting system to avoid rocking or stress to the electronics when mounted on uneven surfaces. Heat is dissipated into our custom manufactured die cast casing and all units will operate at full power without additional heatsink dissipation.

Manual Shutdown Facility
From 40A upwards, the units have the facility to be manually shutdown either through the ignition or a dedicated switch. In addition, from 100A upwards the units can have an override switch fitted. This allows the units to be reactivated for four minutes to allow emergency actions to be performed.

Alarm & Disconnect Delay
An alarm output is provided which, once the threshold has been reached for 10 seconds, will activate, sounding an alarm or other indicating device for a further 50 seconds prior to disconnection. This allows the operator to restart the engine or take other action to maintain continuous power. (alarm not provided)

Timed Versions
In addition to the standard PowerTectors, the PT-T versions offer a timed facility. This will disconnect the output after a set time after the ignition has been turned off. If required, during this time period, the voltage can still be monitored and disconnected if it falls below a set level to protect the battery power and system. The unit will reactivate when the ignition has been turned on again and the battery voltage has reached 8.5Vdc (12V systems), 17Vdc (24V systems).

Fully Programmable
All units in the range are supplied pre-programmed for a variety of scenarios offering higher or lower disconnect voltages and it is quick and simple to select the correct programme to suit your needs.

    Specification Dimensions Data Sheets
    • Automatic referencing - the device automatically adjusts to match the voltage to either a 12 or 24 Volt Battery and sets the appropriate trip levels
    • All PowerTectors from 40A upwards are mounted in a die cast aluminium casing with glass filled polycarbonate cover providing terminal protection and insulation
    • Smaller 20A units are available in a lightweight, polycarbonate casing that can be simply fitted in the wiring, like an in-line fuse
    • Using the simple programming terminal, select the pre-set disconnect voltage according to your requirements
    • Green LED indicates operational status
    • Audible alarm and/or visual indicator can be installed in the dashboard or cockpit to alert operator of a potential problem
    • Switch terminal allows the unit to be operated via the ignition or a manual switch
    • The PowerTector battery guards offer excellent protection for communication and other mission critical applications

    PT20/20T - 155mm x 30mm x 15mm

    PT40/40T/60/60T -  76mm x 78mm x 33mm

    PT100/100T/200/200T -  124mm x 97mm x 51mm

    You recently viewed

    Clear recently viewed